-Anti-scratch scratching board AND cat bed in oneMegaMoto GT Motor Control Shield for Arduino

Title Default Title
Qty:

Description

  • Low-cost robust H-bridge "shield" for the Arduino
  • Built-in cooling fan and heatsinks
  • Up to 50A (5 sec) of current may be controlled
  • Ideal for Arduino users who want to control high current loads efficiently for robotics

The MegaMoto GT Motor Control Shield for Arduino is a low-cost robust H-bridge "shield" for the Arduino and hardware compatible base units. The built-in cooling fan and heatsinks allow the MegaMoto GT to handle high current loads without overheating. Up to 50A (5 sec) of current may be controlled by the MegaMoto GT at 24V. This is over 1200W of power!

The MegaMoto GT is a dual half-bridge circuit that can be configured either has a full H-bridge or as two independent half-bridge circuits. This allows a single MegaMoto GT to drive one motor with full variable-speed control both forward and reverse

  • Supply voltage: 6V to 35V (28V max battery rating)
  • Output Current (continuous): 35A
  • Output Current (surge): 50A+ 5 seconds
  • Weight: 1.8 0z
  • Power MOSFETs: 2 ea. BTN8982
  • PWM Frequency: DC to 20kHz
  • Logic Interface: 3V - 5V , minimum 2 pins required
  • Logic Inputs: Jumper select Enable and PWM source
  • Current Sense Outputs: 0.051V per Amp - 2.55V at 50A
  • Current Sense Pins: Jumper select the analog input connected
  • Current and Temp Limiting: Built into power chips
  • Power Connectors: 4 each metal screw terminals for crimp-on "fork" terminals
  • Enclosure: None